
AnaTek Corporation
100 Merrimack Road, P. O. Box 1200, Amherst, NH 03031
603.321.0884, FAX 603.836.4436, info@anatekcorp.com
Capacitor Wizard with
CapWizSavr
installed $233.00
![]()
The Capacitor Wizard is an extremely fast and reliable device designed to measure ESR (Equivalent Series Resistance) on capacitors of 1uf and larger "IN CIRCUIT", eliminating the need to remove the capacitor for accurate tests. The Capacitor Wizard finds bad caps in circuit that even very expensive cap checkers miss entirely, even out of the circuit!
Why measure ESR? A capacitors physical construction dictates that most capacitor failure modes will adversely affect a capacitors ESR. When a capacitor fails ESR goes up to as high as infinity, depending upon the particular failure mode. An open cap measures infinity. Slight dielectric changes cause ESR to go up by several ohms. Standard capacitor meters cannot detect any change in ESR therefore they miss bad capacitors leading to time consuming "Tough Dog" repairs. A good percentage of your capacitor troubles are caused by an increase in ESR! The Capacitor Wizard will not be fooled!
The Capacitor Wizards method of measurement is based on sound BASIC ELECTRONICS. It is an AC Ohm Meter with its Frequency, Waveform and Measurement Point carefully chosen to maximize its ability to measure low values of ESR (Equivalent Series Resistance) on capacitors of 1uf and up. If a capacitor opens up the Capacitor Wizard measures infinity indicating a drastically bad capacitor. If a capacitor changes value slightly the ESR goes up indicating a bad capacitor. In switching and high current applications (TV Horiz / Vert, Switching Power Supplies, Motor Start and Run Caps) the difference between 0.2 ohms ESR and 2 ohms ESR is very significant!
Many occupations can benefit from using the Capacitor Wizard: TV Repair, Printer Repair, Switching Power Supply Repair, Computer Monitor Repair, Air Conditioning and Refrigeration, Medical Electronics, Electric Motor Repair to name a few.

Meter Range: 0 to 30 Ohms Expanded Scale
Output Test Signal: 100khz Sine Wave
Output Voltage: Only 5 milli volts RMS! - will NOT turn on solid state devices
Meter input resistance: 2.5 Ohm
Meter Resolution as low as 0.1 Ohm
Beeper Resolution as low as 50 milli Ohm
Adjustable "Capacitor Good" beeper
Power: 4 AA Alkaline batteries
Battery Life: Over 60 hours
Size 7" x 4" x 1.5"
Probe length: 4 foot
Recessed "Ohms Zero" and "Beeper Adjust" controls
The Capacitor Wizard has earned the UL Listing Mark for both the United States
and Canada. It conforms to UL3111-1 "Electrical Measuring and Test
Equipment". Representative samples of the Capacitor Wizard have been evaluated by UL
and meet the applicable U.S and Canadian Standards and Requirements. The
Capacitor Wizard also conforms to the European Standard EN-55022 and EN-50082-1 earning
the Capacitor Wizard the "CE"mark.
Made in the USA 