| QUESTION NO. P80403-7: Version 1-3 Playstation 2 power supply 1-468-563-21 with both fuses blown (3.15 and 8A). Found shorted diodes D003, D004 (V08RL155, std rectifiers) and D011 (zener, marked KIV608). I need the specs or a cross for the zener. |
|
This is a Shindengen K1V (not KIV)
Sidac device (not a zener). If an overvoltage occurs, the K1V will
crowbar, like an SCR, rather than merely clamp the voltage. B & D
Enterprises (www.bdent.com)
lists the original K1V, or you can substitute NTE 6416. The TPA62, made
by ST Micro, although a bit different in specs, might also work; Mouser
(www.mouser.com)
lists TPA62.
|
| QUESTION NO. P92402-3: Playstation Sony scph-5502. I need value for D103 on power supply board. |
| There are lots of repair tips and free downloadable schematics here psxhelp.users4.50megs.com, www.geocities.com/psxrepair, www.videogamerepair.com/, www.network54.com/Hide/Forum/47455. |
| QUESTION NO. P320-7: Playstation scph-7502, the power supply does not work because D012, D009, Q001, Q002 and fuse were damaged. I replaced them but they damaged again. I am afraid the values not correct. |
| Look at non-genuine power supplies, they are available and cheap. |
| QUESTION NO. P40302-10: Is there a site for FAQ's on Sony playstations? |
| Sony playstations www.psxworkshop.com. |
| QUESTION NO. P116-8: I need data or an equivalent for part number k2718 fet/transistor? for a Playstation 1. |
| This Playstation transistor is an N-channel MOSFET, Toshiba's 2SK2718, rated at 900 Volts, 2.5 Amps, 40 Watts. A key feature is that this FET's gate is protected by an internal bidirectional TVS device. For more information, the datasheet is at http//doc.semicon.toshiba.co.jp/pdf_e/docweb123/e007610.pdf If you need a substitute, Toshiba's 2SK2700T also is gate-protected, and is carried by Digikey (www.digikey.com). Otherwise, a NTE2959 or IRFIBF30G might substitute, but if no gate protection is provided externally in the circuitry, it may be advisable to add this, such as wiring a SA20CA bidirectional TVS device, from gate to source on the FET. |
| QUESTION NO. P322-2: Need info on semiconductor marked C4231 in Sony Playstation I power supply. |
| Shindengen's 2SC4231 is a 2 Amp, NPN, high-speed switching transistor (Tf < 0.3 usec), rated at 1200 Vcbo, 800 Vceo, 30 Watt. For more information, the datasheet, found at www.bdent.com/schematics/2sc4231.pdf will have gain curves, saturation curves, etc. |
| QUESTION NO. P120-10: Sony Playstation with power supply problems. Already found a shorted 27V zener (D109) and an open current sense resistor (R106). MOSFET on switcher is marked FS3TH, FS3TM or FS3TII - can't really tell (Q101). Can anyone cross? |
| Mitsubishi makes FS3TM FET's, the '3' indicates a 3 Amp rating, and the 'TM' portion indicates a TO-220F (isolated) package. But that device number is incomplete, there is another number that is below the 'TM' part, like a 9, 10, 12, 14, or 16, which you have to multiply by 50 Volts to get the Voltage Rating. For example, a FS3TM-12 would be a 600 Volt, 3 Amp, TO-220F device. So check your FET once again for that number. |
